Philips AZ 2425/17 - Manual (Page 9)

SPEAKERS
Attaching the speakers
• Slide the speakers down into the sleeves on the sides of the
set cabinet. The speakers will click into position.
Taking off the speakers
• Keep the lever (found on the back corner of the speaker)
pressed and slide the speaker upwards.
Connecting the speakers
1. Connect the right speaker to the terminal R, with the red
marked wire to ( + ) and the black wire to ( - ).
2. Clip the exposed portion of wire into the corresponding color
terminal.
3. Repeat the wiring procedure for the left speaker to terminal L,
making sure that you connect the red marked wire to + and
the black wire to –.
Note: – Speakers with an impedance of 4 ohms or higher other
than as supplied may be used instead. Do not, however,
use speakers with a lower impedance as this will result
in damage to your set.
– When headphones are connected to the headphone jack
p the speakers are disconnected.
Switching POWER on/off: Save energy
Whether you are using power or battery supply, to avoid
unnecessary energy consumption always push the POWER button
to the off position after using the set.
Environmental information
All redundant packaging material has been omitted. We have done our utmost to make the
packaging easily separable into three mono materials: cardboard (box), expandable polystyrene
(buffer) and polyethylene (bags, protective foam sheet).
Your set consists of materials which can be recycled if disassembled by a specialized
company. Please observe the local regulations regarding the disposal of packaging
materials, exhausted batteries and old equipment.
REMOVABLE SPEAKERS
9
English
10 mm
- L + + R -
UNLOCK
SPEAKER UNLOCK
SPEAKER
XP AZ 2425/17 19-09-2000 13:19 Pagina 9