Panasonic DMR-ES10 - Manual (Page 11)

RQT8009
11
G
e
tt
ing st
ar
ted
■ If the clock is an hour slower or faster than the
actual time
Select “–1” or “+1” in “Adjust Time Zone” in the SETUP menu
(
➔ page 34).
■ If the unit couldn’t set the clock automatically
Set the time manually ( ➔ page 34, Set Clock Manually).
■ To start Plug-in Auto Tuning again (after
relocation, for example)
When the unit is on and stopped
Press and hold [ 2 CH] and [1 CH] on the main unit for
about five seconds.
The unit turns off.
Press [ ^ DVD POWER] to turn the unit on.
1
Press [SETUP].
2
Press [ e, r] to select “Channel” and
press [ q].
3
Press [ e, r] to select “Signal Source
(RF IN)” and press [ENTER].
4
Press [ e, r] to select “Antenna” or
“CableTV” and press [ENTER].
5
Press [ e, r] to select “Set Channels
Automatically” and press [ENTER].
6
Press [ENTER].
Auto Channel Setting starts. This takes a few minutes.
7
Press [ENTER].
To cancel partway
Press [RETURN].
To exit the screen
Press [SETUP].
Add or delete channels if necessary channels are not set or
unnecessary channels are set.
1
Press the numbered buttons to select
a channel.
•
You can also use [ 1 2 CH] when you are going to delete a
channel.
2
Press [ADD/DLT].
e.g., The channel is deleted.
Signal source, channel caption, and VCR Plus+ guide
channel settings all revert to the default values when you
perform the procedure below. Scheduled recording settings
are also cleared.
If Plug-in Auto Tuning fails
1
2
Channel Captions
CableTV
Channel
SETUP
Setup
Disc
Video
Audio
Display
TV Screen
Signal Source (RF IN)
Set Channels Automatically
Preset Channel Captions
Manual Channel Captions
VCR Plus+ Ch. Setting
SETUP
Setup
Video
Audio
Display
TV Screen
Channel
Signal Source (RF IN)
Antenna
CableTV
Disc
ENTER
Adding and deleting channels
CH
Antenna Mode (Airwaves)
e.g.,
5: [0] ➔ [5]
15: [1] ➔ [5]
CableTV Mode (Cable)
e.g., 5:
[0] ➔ [0] ➔ [5]
15: [0] ➔ [1] ➔ [5]
115: [1] ➔ [1] ➔ [5]
Unit’s display
Channel 15 Deleted