Philips WV-NW484S - Manual (Page 36)

Network Setup (continued)
36
1
Launch the IP setup software.
2
Click the MAC address/IP address of
the camera to set up, and click the [IP
setting] button.
.................................................. Note
• When a DHCP server is in use,
you can check the IP address
assigned to the camera by clicking
the [Refresh] button in the IP
setup software.
......................................................
3
Enter each of the network items, and
click the [Apply] button.
.................................................. Note
• When a DHCP server is in use,
"DNS" in the IP setup software
can be set to "Auto".
......................................................
Important
• It takes about 30 seconds for settings on the camera to complete after clicking the
[Apply] button. The settings will be invalid if the camera is turned off or the Ethernet
cable is disconnected before setting is complete. If this happens, make the settings
again.
• When a firewall (including software) has been installed, allow access of all UDP ports.
2
2
3