Philips WV-NW484S - Manual (Page 19)

19
About Static Electricity Removal
Before installing the camera, touch a metal
case or other metallic parts with your hand
to remove static electricity from your body.
Do not install in areas subjected to high
amounts of humidity or dust.
Doing so may cause internal components
to damage more easily or malfunction.
Do not wire cables near power lines.
Configure the power supply to the
camera so that it can be turned on and
off.
The camera does not have a power switch,
so configure the power supply to the
camera so that it can be turned on and off.
Network Connection
Pay attention to the following points when
using the camera's network cable to
connect to a network.
• Wire and install the camera so that the
network will not be influenced by
lightning surges, etc.
• Pan and tilt cannot be used in combina-
tion with this camera.
Tightening the Screws
Screws should be tightened sufficiently in
accordance with the materials and
structure of the installation location. After
tightening the screws, visually inspect them
to make sure there is no unevenness and
that each screw is tight.
Screws should be ordered separately.
The camera does not come with screws.
Choose screws in accordance with the
materials and structure of the installation
location.
Electrical Wave Interference
The image may fluctuate near TV or radio
transmission antennas, or near strong
electric or magnetic fields (e.g. motors or
transformers). In this case, setup a special-
ized thin conduit and pass the cable
through it.
Power Supply by PoE
Use a PoE-compatible (IEEE802.3af-
compliant) hub or power supply unit.