Patton electronic Model 1058 - Manual (Page 7)

7
3.0 INSTALLATION
Because the Model 1058 requires no configuration, it can be installed
and made operational quickly. Installation takes place as follows:
1. Connecting the line interface between the units (refer to section 3.1,
“Connecting the Twisted-Pair Line Interface” on page 7)
Note See Figure 2 for the rear panel arrangements.
2. Connecing the Ethernet interface (refer to section 3.2, “Connecting
the 10/100Base-T Ethernet Interface” on page 9).
3. Connecting the power plug (refer to section 3.4, “Connecting Power”
on page 11).
Figure 2. Model 1058 standalone rear panel
3.1 CONNECTING THE TWISTED-PAIR LINE INTERFACE
The Model 1058 supports communication between two peer Ethernet
LAN sites over a distance of up to 4,652 ft (1,418 m) over 24 AWG (0.5
mm) twisted-pair wire.
Note Actual distance and link performance may vary depending on
the environment and type/guage of wire used.
Ether
net
VDSL Link
Po we
r
M ade in the U SA
POTS/ISDN
twisted-pair
terminal block
interface
Power
jack
Ether
net
VDSL Link
Po we r
M ad e in the
U SA
Ethernet
port
VDSL twisted-pair
terminal block
interface
VDSL twisted-pair
RJ-45 interface
PO
TS/ISDN
1058DV
1058D