Philips MIIC-201D/U - Manual (Page 11)

5
Use of the +5V wire in the I 2 C Interface connector is optional. Connect this wire to
the target system to power the target system from either:
1 USB derived power. Maximum available target system power is 100 ma at
+5V.
2 A +5VDC Power Jack connected external +5V regulated power supply.
Maximum available target system power is 250 ma at +5V.
Receptacle Connector
An I 2 C Clip-Lead cable is provided to connect the I 2 C adapter to a target system.
Each clip-lead is clearly marked (C=SCL, V=+5VDC, D=SDA, G=Ground).
An I 2 C Interface Cable (White=SCL, Red=+5VDC, Green=SDA, Black=Ground) is
also provided to connect the I 2 C adapter to an external I 2 C Bus. Since there is no
standard I 2 C Bus connector, you may want to cut off one end of the cable and add a
connector compatible with your target system. Additional I
2
C Interface Cables (4
ft., 8 ft., or 16 ft.), and modular connectors are available from MCC. Additional
Clip-Lead cables are also available. (see Appendix A)