Setting the clock, Setting the rf out channel – Philips VR150/07 User Manual
Page 8
EN
Setting the clock
If the display shows an incorrect time or ' --:-- ',
the time and date must be reset manually.
1.
1.
Switch on the TV. If required, select the pro-
gramme number for the video recorder.
2.
2.
Press
. The main menu will appear.
3.
3.
Select 'INITIAL SET UP' with
or
and confirm with
.
4.
4.
Select 'CLOCK' with
or
and confirm with
.
5.
5.
Check the time in 'TIME'. If required, please
change the time with
.
6.
6.
Check 'DAY', 'MONTH' and 'YEAR' in the
same way.
7.
7.
To end, press
.
Setting the RF out channel
In some reception locations it is possible that a
TV channel will be sent on the same or similar
frequency as the video recorder.
Result: As soon as the video recorder is
switched on, the reception quality for this or sev-
eral other TV channels will decrease.
The following steps will show you how to change
the pre-set 'transmission' (RF out channel) fre-
quency on the video recorder.
1.
1.
Switch on the TV. If required, select the pro-
gramme number for the video recorder.
2.
2.
Press
. The main menu will appear.
3.
3.
Select 'INITIAL SET UP' with
or
and confirm with
.
4.
4.
Select 'RF OUT' with
or
and confirm with
.
5.
5.
Press .
6.
6.
Press , or to
select
the channel which is not broadcasted
between channel 22 and channel 69 in your
area.
7.
7.
Press
.
8.
8.
To end, press
.
STATUS/EXIT
FWD 1- B
0..9
STOP C-L
PLAY B-K
FWD 1- B
FWD 1- B
STOP C-L
PLAY B-K
FWD 1- B
STOP C-L
PLAY B-K
MENU
STATUS/EXIT
0..9
FWD
1
- B
STOP C-L
PLAY B-K
FWD 1- B
STOP C-L
PLAY B-K
MENU
TIME --:--
DATE --/--/--
END=EXIT
What is RF out channel?
This electronic component in the video recorder
allows the device to transmit audio and video
signals via the aerial cable. These signals can
be received on the TV just like TV channels.
What is RF out channel frequency?
This frequency or channel indicates the channel
on which the audio or video signal is transmitted.
SELECT
K L
CHOOSE B
→RF OUT CH 35
END=EXIT
8
If you cannot get an interference-free picture
and sound, connect the video recorder and
the TV with a scart cable. Then, switch the
built-in modulator off. Press
repeatedly until ' -- ' appears next to 'RF
OUT CH' on the TV screen.
Then confirm with
.
FWD 1- B
STOP C-L
HG271BD(EN).qx3 04.1.23 8:25 PM Page 8