Philips VR150/07 User Manual

Page 3

2. Important notes for operation

Navigation in the screen menu

You can check/change many functions and settings
of your video recorder via the on-screen menu. The
individual functions are selected, via the remote
control as follows:

Call up the menu: with .

To select: with .
To enter or change your selection: with the num-
ber buttons

or with

To save or confirm: with .
To cancel: with .
To end: with .

The symbols on your video recorder
display

These symbols can light up on your video recorder dis-
play:

When you keep your video recorder on.

When you have put a cassette in the video
recorder.

Display of programme number of the TV channel /
time / RF channel.

When you record.

When you have programmed a recording.

STATUS/EXIT

CLEAR

FWD

- B

STOP C-L

PLAY B-K

0..9

STOP C-L

PLAY B-K

MENU

SELECT K L CHOOSE B

→TIMER

RECORD SET UP
VCR SET UP
TUNER SET UP
INITIAL SET UP

END=EXIT

Switching on
You can switch on the video recorder with the

button.

Automatic switch-off
If the video recorder is not used for several minutes, it switches itself off automatically. This function can
be deactivated (e.g. if you want to use the video recorder as a TV receiver). For more information, please
read the section 'Automatic switch-off' in chapter 'Other functions'.
Time in the display
If you have switched the video recorder off with

, the time will show in the display, e.g.

'18:00'.
If the clock has not been set, ' --:-- ' will appear.
Power consumption
The video recorder should always be connected to the mains so as not to affect the use of the TV or
programmed recordings.
If the display has been switched off, your video recorder consumes less than 3W in stand-by.
Power outage/no power
Channel information remains saved for up to 1 year, the time and timer information is saved for up to 1
minute.

STANDBY/ON y

Front of your VCR

To switch off or on, interrupt menu

function.

To select the

programme number. During playback, press to adjust the

tracking.

To record the TV channel selected at this

moment.

When tape playback is stopped, press to fast

forward the tape at high speed. During playback, press to

fast forward the tape while the picture stays on the screen.

When tape playback is stopped, press to rewind the tape

at high speed. During playback, press to rewind the tape

while the picture stays on the screen.

To play back a tape.

To stop the tape and eject the

cassette.

Back of your VCR

To connect the TV.

To connect the aerial cable.

To connect the TV.

RF OUT

AERIAL

STOP/EJECT

PLAY

REW.

FWD.

RECORD

PROGRAMME-

PROGRAMME+

STANDBY/ONy

HG271BD(EN).qx3 04.1.23 8:25 PM Page 3