Polycom DOC2558A - Manual (Page 38)

Chapter 1- Hardware Description
1-32
3 Use the metal ejector levers to pull the CNTL Module out of its slot in
the Backplane.
4 Carefully slide the CNTL Module out through the front panel.
5 On the CNTL Module to be installed, move the ejector lever to the
fully open position.
6 Slide in the replacement CNTL Module.
7 Push the CNTL Module firmly into the Backplane, making sure it is
properly seated in its slot.
8 Ensure that the metal ejector levers are fully retracted into their
housings.
9 Tighten the captive screws on the front panel of the RMX 2000 that
secure the Functional
CNTL Module.
10 Turn ON the RMX 2000.
For more information on the Card Configuration Modes after reset, see "MPM/
MPM+ and MPMx Configuration Modes” on page
1-22 .