Pertech 5300 - Manual (Page 18)

Pertech Resources Inc. November 2005 220321A 12
11. Click “Finish”. Windows will issue a warning that the
driver is not digitally signed by Microsoft®. To install the
driver, click “Continue.”
Print Driver Setup
COMx Port Set up
If using RS-232, it is likely that first time installers will
need to adjust the RS-232 parameters to match the
attached printer. After installing the driver, go to “Print-
ers and Faxes” on the “Start” menu and right click on
the 53xx printer driver. Select “Properties”. Select the
“Ports” tab. Select “Configure Port”. Verify that the baud
rate, parity data and stop bits and flow control match.
VERY IMPORTANT: Make sure that the Windows COM
port is set for Flow Control = Hardware (or XON/XOFF if
the attached printer is configured to for XON/XOFF). If
Flow Control is set to “None”, garbage print may eventu-
ally result. To check the printers configuration settings
see the next section of this manual “ Configuration &
Diagnostic Print Tests”.