beautypg.com

Getting your baby cam ready, Channel selection – Philips SCD491 User Manual

Page 9

background image

EN

Getting your baby cam ready

10

4 Slide the battery compartment cover (B-7) back in place.

Push gently until it clicks into position.

5 Pull down the belt clip/support (B-15) slide it upwards until it

clicks into position.

6 Connect the power adapter cord to the unit power supply

jack (DC 8.0V -

-<

<+

+

- B-12).

7 Connect the AC power adapter (B-10) to a wall outlet.

Unwrap and fully extend the AC adapter cord.

8 Leave the monitor unit connected to the mains supply until

the batteries are fully charged (at least 10 hours).
> During recharging the POWER light (B-1) blinks red.
> When batteries are fully charged the POWER light (B-1)

lights continuously green.The monitor unit can now be
used cordlessly for at least 3.5 hours.

The monitor unit is now ready for battery-operated
use.

Positioning the monitor unit
• The unit can be placed on a stable, flat surface such as a table

top.

• The belt clip can be used to support the unit in an inclined

position. For this, slide down the belt clip (B-15) and lift it up.

Channel selection

1 Use the CHANNEL selection switch (A-7) on the camera

unit to select the desired channel (1, 2 or 3).

2 Set the CHANNEL selection switch (B-5) on the monitor

unit to the corresponding channel.

• Make sure that both units are always set to the same

channel.