beautypg.com

Using your baby cam, Adjusting the image, General remarks – Philips SCD491 User Manual

Page 11

background image

Adjusting the image

Adjusting the focus of the image (camera unit)
Use the focus ring (A-2) to adjust the focus of the image.

Adjusting the horizontal and vertical angle of the image (camera
unit)
Turn the camera head left or right to adjust the horizontal

angle of the image.

Slide the camera head up or down the slot to adjust the

vertical angle of the image.

Adjusting the brightness of the display (monitor unit)
Use the

1 BRIGHTNESS 2 control (B-14) to adjust the

brightness of the display (B-2).

General remarks

Low power indication
When the camera unit POWER light (A-10) goes out, battery

power is low. Switch over to mains power or replace
batteries.

When the monitor unit POWER light (B-1) starts blinking

green (when in use) or lights up red (after switching on),
battery power is low. Switch over to mains power or
recharge batteries.The batteries should recharge for
10 hours.When the unit is in use, recharging time will
increase. During recharging the POWER light (B-1) blinks red.
When batteries are fully charged the POWER light (B-1)
lights continuously green.
When batteries do not fully recharge or not at all, battery life
is at an end. Replace batteries.

EN

Using your baby cam

12