Appendix – Pantech Lena C610 User Manual

Page 79

06
07

Appendix

Statement according to FCC part 15.105
NOTE: This equipment has been tested and found to comply with

the limits for a Class B digital device, pursuant to Part 15 of the FCC

Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment

generates, uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause

harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If

this equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment off and on,

the user is encouraged to try to correct the interference by one or more

of the following measures:
– Reorient or relocate the receiving antenna.

– Increase the separation between the equipment and receiver.

– Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected.

– Consult the dealer or an experienced radio/TV technician for help.

Statement according to FCC part 15.21
Modiﬁcations not expressly approved by this company could void the

user’s authority to operate the equipment.

RF exposure FCC
For body worn operation, to maintain compliance with FCC RF exposure

guidelines, use only accessories that contain no metallic components

and provide a separation distance of 15mm (0.6 inches) to the body.

Use of other accessories may violate FCC RF exposure guidelines and

should be avoided.
This device and its antenna must not be co-located or operating in

conjunction with any other antenna or transmitter.

Health and Safety Information FCC
This EUT has been shown to be capable of compliance for localized

speciﬁc absorption rate (SAR) for uncontrolled environment/general

population exposure limits speciﬁed in ANSI/IEEE Std. C95.1-1992

and had been tested in accordance with the measurement procedures

speciﬁed in FCC/OET Bulletin 65 Supplement C (2001) and IEEE Std.

1528-2003 Ministry of Health (Canada), Safety Code 6. The standards

include a substantial safety margin designed to assure the safety of

all persons, regardless of age and health. The exposure standard for

wireless mobile phones employs a unit of measurement known as the

Speciﬁc Absorption Rate, or SAR. The SAR limit set by the FCC is

1.6W/kg *.

* In the U.S. and Canada, the SAR limit for mobile phones used by the

public is 1.6 watts/kg (W/kg) averaged over one gram of tissue. The

standard incorporates a substantial margin of safety to give additional

protection for the public and to account for any variations in.

** This device contains 1800 MHz GSM and 900 MHz EGSM functions

that are not operational in U.S. Territories; this ﬁling is applicable only

for 850 MHz GSM and 1900 MHz PCS operations.