Philips CED370/00 - Manual (Page 38)

39
English
EN
Video connection is improper. Check the •
connections.
Noise in broadcasts.
Signals are too weak. Select other stations •
with stronger signals.
Check the connection of the car antenna.
•
Change broadcast from stereo to mono. •
Preset stations lost.
Battery cable is not correctly connected. •
Connect the battery cable to the terminal
that is always live.
Fuse is broken
The Fuse type is incorrect. Replace it with •
a 15A fuse.
Speaker wire or power wire is grounded.
•
Check the connections.
Display show ERR-12
USB data error. Check the USB device. •
About Bluetooth device
Music playback is unavailable on the system
even after successful Bluetooth connection.
The device cannot be used with the •
system to play music.
The audio quality is poor after connection
with a Bluetooth-enabled device.
The Bluetooth reception is poor. Move •
the device closer to the system or
remove any obstacle between the device
and the system.
Cannot connect with the system.
The device does not support the profiles •
required for the system.
The Bluetooth function of the device is
•
not enabled. Refer to the user manual of
the device for how to enable the function.
The system is not in the pairing mode.
•
The system is already connected with •
another Bluetooth-enabled device.
Disconnect that device or all other
connected devices and then try again.
11 Troubleshooting
Caution
Never remove the casing of this apparatus. •
To keep the warranty valid, never try to repair
the system yourself.
If you encounter problems when using this
apparatus, check the following points before
requesting service. If the problem remains
unsolved, go to the Philips web site
(www.philips.com/support). When you
contact Philips, ensure that your apparatus
is nearby and the model number and serial
number are available.
No power
Car engine has not been started. Start •
the car engine.
Connections is incorrect.
•
Fuse has been damaged. Replace fuse. •
No sound
Volume is too low. Adjust volume. •
Speaker connections is incorrect. •
Disc does not play
Disc is upside down. Ensure the printed •
side is upwards.
Disc is dirty. Clean the disc with a
•
clean, soft, lint-free cloth. Wipe the disc
outwards from the center.
Disc is defective. Try another disc.
•
incompatible disc is used. Try another disc. •
Disc rating exceeds the restrict setting. •
Change the rating settings to lower one.
Disc region code is not compatible with
•
the unit. Use disc with proper region code.
No image
Parking brake wire connection is •
incorrect. Check the parking wiring.
Image flashes or distorted
Video DVD settings do not match with •
the DVD. Adjust video DVD settings.