Philips CED370/00 - Manual (Page 12)

13
English
EN
Connector Connect to
1 Yellow wire The +12V car battery
which is live at all times.
2 Blue wire The electric antenna
control lead or power
supply lead of the
antenna booster
If there is no electric
antenna or antenna
booster, or it is manually
operated telescopic
antenna, it is not necessary
to connect this lead.
3 Orange wire Illumination switch
4 Black wire A metal surface of the
car
First connect the black
ground (earth) lead, then
connect the yellow and
red power supply leads.
5 Red wire The +12V power terminal
which is live in the
accessory (ACC) position
of the ignition switch
If there is no accessory
position, connect to the
+12V car battery terminal
that is always live. Be
sure to connect the black
ground (earth) lead to a
metal surface of the car
first.
6 Green and
green/black
wires Left speaker (Rear)
7 White and
white/black
wires Left speaker (Front)
8 Gray and
gray/black
wires Right speaker (Front)
9 Purple and
purple/black
wires Right speaker (Rear)
Connect wires: without ISO
connectors
Caution
Ensure that all loose leads are insulated with •
electrical tape.
1
Cut off the bigger end of the supplied
standard connector.
2
Check the car’s wiring carefully, then
connect them to the standard connector.
2
1
3
4
5
6
7
8
9