Paradyne Hotwire 5038-A1-00 - Manual (Page 3)

3
Installing the POTS Splitter Without an RTU
Each POTS splitter connected to a phone without an RTU uses two cables with RJ11
connectors. The two cables are installed:
H
From the Local Loop to the POTS splitter (supplied cable)
H
From the POTS splitter to the telephone (existing cable)
98-15813
POTS
Splitter
Line from
Local Loop
RJ11 Jack
Telephone
PHONE
LINE
DSL
PHONE
LINE
DSL
PHONE
LINE
DSL
Line from
Local Loop
POTS
Splitter
POTS
Splitter
RJ11 Jack
Telephone
Customer
Premises (CP)
"
Procedure
To connect a POTS splitter to a phone without an RTU:
1. Unplug the existing cable from the local loop to the telephone.
2. Plug the existing cable into the POTS splitter jack labeled PHONE.
3. Plug one end of the supplied cable into the POTS splitter jack labeled LINE. Plug
the other end into the line from the local loop.
98-15852
POTS Splitter
Line from Local Loop
(Supplied Cable)
LINE
DSL
PHONE
PHONE
RJ11
Jack
PHONE
LINE
(Existing
Cable)