beautypg.com

Rmds vcr tv dvd subwoofer cable, Getting started, Basic setup – Polk Audio RMDS-1 User Manual

Page 6: Carton contents

background image

Polk customer service (800) 377-7655

6

Carton Contents

Your new Polk Audio RM Digital Solution system comes in two
cartons. If you do not have any of the pieces listed below,
or if any component seems damaged, contact your Polk Audio
retailer immediately.

Carton 1:
One (1) RMDS-1 Preamp/Processor
One (1) Infrared remote control
Two (2) AA batteries for remote
Four (4) RM front and surround satellite speakers
One (1) RM center channel satellite speaker
Four (4) satellite wall-mount brackets with screws
Twenty (20) adhesive-backed rubber pads
Three (3) 20' (6M) speaker cables
Two (2) 40’ (12M) speaker cables
One (1) 4 Meter DB-25 interconnect cable
One (1) 4 Meter DB-25 interconnect cable
One (1) FM antenna wire
One (1) AM loop antenna

Carton 2:
One (1) RMDS-1 subwoofer with integrated 6 channel
power amplifier
One (1) IEC-type AC power cable

Quick Start Guide (see illustrations on pages 8 and 9)

1. Remove all of the components and accessories from the
shipping cartons.
2. Connect sources such as DVD player, VCR, etc. to the RMDS-1
audio and video inputs using coaxial (RCA-type) cables.
3. Connect the video output of the RMDS-1 preamp/processor to a
video input on your TV.
4. Connect the RMDS-1 to the subwoofer with the supplied 4
meter DB-25 cable.
5. Using the supplied speaker wires, connect the speakers to the
speaker terminals on the back of the subwoofer. Be sure to
maintain correct polarity ( + to +, - to -) on all channels. The wire
with the black band should always be connected to the black ( - )
terminal and the wire with the color band should always be
connected to the red ( + ) terminal.
6. Plug the AC cord that was in the subwoofer box into the AC
receptacle on the subwoofer.
7. Plug the AC cords from the preamp/processor and subwoofer
into 120V/60 Hz AC power outlets.
8. Turn the power switch on the subwoofer to the "Standby"
position.
9. Press the power button on the preamp/processor front panel or
remote control.
10. Select the input of your choice.
11. Set volume and bass level to taste and enjoy!

GETTING STARTED

RMDS

VCR

TV

DVD

SUBWOOFER

CABLE

COAX1

DIGITAL

STEREO

TEST

MEMO

AUTO

PCM

power ———— standby

source

on/off

surround

multi-room

tune

save

preset

clear

presets

TUNED

OPT

NIGHT

PROLOGIC

P-SCAN

STEREO

MULTI

COAX2

db

kHz
MHz

DOLBY

D I G I T A L

R M D I G I T A L S O L U T I O N

I N T E L L I G E N T A / V P R E A M P / P R O C E S S O R / L O U D S P E A K E R S Y S T E M

aux. inputs

S-video

volume

video

L..audio..R

BASIC SETUP