Panasonic DMR-EH50 - Manual (Page 39)

39
RQT8023
E
d
itin
g
After performing steps 1–5 ( ➡ 38)
§ Multiple editing is possible.
After performing steps 1–7 ( ➡ 38)
§ Multiple editing is possible.
Title operations
Erase Title §
[HDD] [RAM] [-R] [-RW‹V›] [+R]
( ➡ below, “For quicker
editing”)
Press [ 2 , 1 ] to select “Erase” and press [ENTER].
≥ Once erased, the recorded contents are lost and cannot be restored. Make certain before proceeding.
≥ The available recording space on DVD-R or +R does not increase when you erase titles.
≥ Available recording space on DVD-RW (DVD-Video format) increases only when the last recorded title is
erased. It does not increase if other titles are erased.
Properties
[HDD] [RAM] [-R] [-RW‹V›] [+R]
[-RW‹VR›]
Information (e.g., time and date) is shown.
≥ Press [ENTER] to exit the screen.
Title Name
[HDD] [RAM] [-R] [-RW‹V›] [+R]
You can give names to recorded titles.
➡ 53, Entering text
Setup Protection §
Cancel Protection §
[HDD] [RAM]
If set, this will protect the title from accidental erasure.
Press [ 2 , 1 ] to select “Yes” and press [ENTER].
The lock symbol appears when the title is protected.
Shorten Title
[HDD] [RAM]
( ➡ below, “For quicker
editing”)
You can remove unnecessary part of the recording such as commercials.
1 Press [ENTER] at the start point and end point of the
section you want to erase.
2 Press [ 3 , 4 ] to select “Exit” and press [ENTER].
≥ Select “Next” and press [ENTER] to erase other sections.
3 Press [ 2 , 1 ] to select “Erase” and press [ENTER].
Change Thumbnail
[HDD] [RAM] [-R] [-RW‹V›] [+R]
( ➡ below, “For quicker
editing”)
You can change the image to be shown as the thumbnail picture in the Title View.
1 Press [ 1 ] (PLAY) to start play.
2 Press [ENTER] when the image you want to use as a
thumbnail is shown.
To change the thumbnail
Restart play and press [
3 , 4 ] to select “Change”, then press [ENTER] at
the point you want to change.
3 Press [ 3 , 4 ] to select “Exit” and press [ENTER].
Divide Title
[HDD] [RAM]
( ➡ below, “For quicker
editing”)
You can divide a title into two.
1 Press [ENTER] at the point you want to divide the title.
2 Press [ 3 , 4 ] to select “Exit” and press [ENTER].
3 Press [ 2 , 1 ] to select “Divide” and press [ENTER].
To confirm the division point
Press [
3 , 4 ] to select “Preview” and press [ENTER]. (The unit plays 10
seconds before and after the division point.)
To change the division point
Restart play and press [
3 , 4 ] to select “Divide”, then press [ENTER] at the point where you want to divide
the title.
[Note]
≥ The divided titles retain the name and CPRM property ( ➡ 68) of the original title.
≥ Video and audio just before and after the dividing point may momentarily cut out.
Properties
No.
Ch.
Date
001
4
6/20/2002
Start
Rec. Time
10:00 AM
2:15 (SP) Wed
Dinosaur
ENTER
10 10/27 Mon
007 008
8 10/27 Mon
- - - - - -
DIRECT NAVIGATOR Title View
HDD
Start
Next
Exit
0:43.21
Play 008
End
- -:- -.- - - -:- -.- -
Start End
DIRECT NAVIGATOR Shorten Title
HDD Picture Video
ENTER
Change
Exit
0:00.01
0:01.05
Change
008
DIRECT NAVIGATOR Change Thumbnail
HDD
Start play and select
the thumbnail position
Picture Video
ENTER
Preview
Exit
Divide
0:43.21
-- : -- . --
Divide
008 Play
DIRECT NAVIGATOR Divide Title
HDD Picture Video
ENTER
Chapter operations
Erase Chapter §
[HDD] [RAM]
Press [ 2 , 1 ] to select “Erase” and press [ENTER].
≥ Once erased, the recorded contents are lost and cannot be restored. Make certain before proceeding.
Create Chapter
[HDD] [RAM]
( ➡ below, “For quicker
editing”)
Select the point where you want to start a new chapter while viewing the
title.
1 Press [ENTER] at the point you want to divide.
≥ Repeat this step to divide at other points.
2 Press [ 3 , 4 ] to select “Exit” and press [ENTER].
Combine
Chapters
[HDD] [RAM]
Press [ 2 , 1 ] to select “Combine” and press [ENTER].
≥ The selected chapter and following chapter are combined.
Create
Exit
0:43.21
Play 008
DIRECT NAVIGATOR Create Chapter
HDD Picture Video
ENTER
For quicker editing
≥ Use search, slow-motion ( ➡ 31) or Time Slip ( ➡ 32) to find the desired point.
≥ Press [ : , 9 ] to skip to the end of a title.
EH50English.book Page 39 Tuesday, February 1, 2005 6:36 PM