Peavey X-Four - Manual (Page 67)

p. 67
master module
monitor output features
The MONITOR output section controls the audio feed for the console oper-
ator. Features are similar to those of ALT OUT section, except that the MON -
ITOR section is normally used to access the SOLO system as well as main
outputs.
Like the alternate output section, it provides the ability to assign the left
and right
MASTER signals to a designated pair of balanced male XLR con-
nectors on the rear-panel.
By utilizing the mode switches located below the LOCAL MONITOR OUTPUT
level control, these signals can be derived in a number of different ways. In
default mode (no switches depressed), the post-fader left and right
MASTER
signals are routed through LOCAL MONITOR level control and appear at the
MONITOR OUT balanced male XLR connectors on the rear-panel.
This feed is replaced by the SOLO signal when a SOLO is activated on the
console.
monitor-out level
see—alternate out
sum mono
see—alternate out
solo-off
When any of the AFL / PFL switches on the console are active, the
AFL / PFL audio is routed in stereo through the MONITOR OUT level control
and appears at the left and right MONITOR OUT balanced male XLR con-
nector on the rear-panel.
This setting overrides the left and right feed to the MONITOR output.
When any of the AFL / PFL switches on the console are active, the
MONITOR outputs are not affected.
headphone level
This control governs the level at the headphone jack located in the
front of the console under the arm rest.
5