Master module, Alternate out features – Peavey X-Four User Manual
Page 65
p. 65
master module
alternate out features
The
ALTERNATE
output section allows assignment of the left and right
MASTER
signals (plus center—if
LCR
-
TO
-
OUTPUTS
is selected) to a separate pair of bal-
anced male XLR connectors on the rear-panel.
By utilizing the mode switches located below the
ALT OUT
level control,these
signals can be derived in a number of ways. In default mode (no switches
depressed), the post-fader left and right
MASTER
(in center) signals are rout-
ed through the
ALT OUT
level control and appear at the
ALT OUT
connectors.
alternate out level
This control sets the levels that appear at the
ALT OUT
left and right
balanced
XLR
connectors on the rear-panel.
sum mono
The main left and right (and mono/center) signals are summed
together as a mono signal.This signal is then routed through the
ALT OUT
level control and appears at the left and right
ALT OUT
balanced male
XLR
connectors on the rear-panel.
The main left and right (and mono/center) signals are routed in
stereo through the
ALT OUT
Level control and appear at the left and right
ALT OUT
balanced male
XLR
connectors on the rear-panel.
pre switch
The left and right (and mono/center) master faders have no effect on
the left and right (and mono/center) signals routed through the
ALT OUT
level control and appear at the left and right
ALT OUT
balanced male
XLR
connectors on the rear-panel.
The left and right (and mono/center) master faders control the lev-
els of the left and right (and mono/center) signals routed through the
ALT
OUT
level control and appear at the left and right
ALT OUT
balanced male
XLR
connectors on the rear-panel.
5