Premier Mounts Polaris Universal Projector Mount MAG-PRO User Manual
Page 6

MAG-PRO
Page - 6 -
Installation Manual
Ceiling Installation
The Polaris™ Pro may be attached to 1-1/2” standard threaded pipe (NPT), or one of Premier Mounts adjustable-height
ceiling adapters (Models AST-2446 and APP-2446). If the user purchases an AST-2446 or an APP-2446, please refer to
the installation instructions that come with these adapters.
1. Thread the MAG-PRO onto the length of 1-1/2” NPT, or any
of Premier Mounts compatible adapters.
When attaching the MAG-PRO to the pipe, please
ensure that the MAG-PRO is threaded on at least four
(4) complete turns.
2. Secure the MAG-PRO by tightening the set screw with the
M3 security Allen wrench (supplied).
3. Route any cables up through the 1-1/2” NPT and into the
ceiling structure.
THE MAGNETS ARE USED FOR GUIDING THE
UNIT ONLY! PLEASE MAKE SURE THE TWO
(2) M4 X 12MM SCREWS ARE USED TO
SECURE THE PROJECTOR.
If the PP-FCTA Ceiling Mount is to be used, the
CLS must first be threaded into the MAG-PRO. For
further installation instructions, please refer to the
PP-FCTA installation manual.
Attaching the Projector
1. Once the coupler is tightened and secure, raise the projector,
allowing MagnaGuide® Technology to “guide” the lower
assembly into the upper assembly.
2. Once attached, secure on each side of the Magnaguide®
locking assembly using two (2) M4 x 12mm security screws
and star washers.
Do not release your hold on the projector until the
upper and lower assemblies are secured with the
two (2) M4 x 12mm security screws and star washers.
Adjusting the Projector
1. Loosen the M5 set screw using the M5 Allen wrench (both
sides).
2. Adjust the projector to the correct position. Firmly grasp the
projector in both hands, and tilt either forward or backward
to adjust the level.
-OR-
Firmly grasp the projector in both hands and rotate side to
side for orientation adjustment.
3. Tighten the M5 set screw on both sides using the M5 Allen
wrench.
M5 Set Screw
1-1/2” NPT
Pipe
MAG-PRO
M3 Security
Allen Wrench
Cable Access
M4 x 12mm
Security Screw
and Washer
M5 Security
Allen Wrench
M4 x 12mm
Security
Screws and
Star Washer
M4 x 12mm
Security
Screw and
Washer