Philips DVD741VR - Manual (Page 17)

POWER
MARKER
OUTPUT SELECT
3
4 5 6
TIMER SET
2 1
VCR DVD
CLEAR
REPEAT
SETUP
TITLE RETURN MODE
CHANNEL/SKIP
A-B
AUDIO ANGLE SUBTITLE
REC/OTR REPEAT
DISC
MENU OK
PAUSE
REW FF
PLAY STOP
VCR/TV
MEMORY
Disc Playback 17
• An “X” may appear at the top right
corner of the TV screen when you
try a feature. Either the feature is
not available on the Disc, or the
DVD/VCR cannot access the feature
at this time.This does not indicate a
problem with the DVD/VCR.
• If a Disc is dirty or scratched, the
pictures may appear distorted or
playback may stop. Remove the
Disc and turn off the DVD/VCR.
Disconnect the power cord, then
reconnect it. Clean the Disc, then
turn on the DVD/VCR again and
reinsert the Disc for playback.
• When the DVD or CD light appears
on the display panel, the Disc is
loaded completely and is ready for
playback.
• When you press OPEN/CLOSE or
PLAY (DVD) on the front of the
DVD/VCR when the power is off,
the DVD/VCR will turn on automati-
cally and will be in DVD mode.
Helpful Hints
● Before you begin, turn on the power of the TV, stereo receiver
and any other equipment connected to the DVD/VCR. Make
sure the TV and the stereo receiver (if applicable) are set to
the correct channel. Details are on pages 8-13.
1 Press POWER y y to turn on the DVD/VCR. “P-ON”
will appear briefly on the display panel.The DVD/VCR will
be in VCR mode.
2 Press OUTPUT SELECT so the red DVD light
appears on the front of the DVD/VCR.Then, press
DVD.
3 Press OPEN/CLOSE on the front of the DVD/VCR
to open the Disc tray.
4 Place a Disc into the tray.
Some DVDs are recorded on both sides. Make sure the
side you want to play is facing up. Or, if the DVD is record-
ed on only one side, place the Disc in the tray with the
label facing up.
5 Press PLAY B (o). The tray will close automatically, and
playback will begin at the first Chapter or Track of the
Disc.
Or, you may press OPEN/CLOSE or press the tray toward
the DVD/VCR to close the tray; DVD playback will start
automatically.
If a DVD menu appears instead, see page 48.
With some Audio CDs, playback will not begin unless you
press PLAY B (o).
6 Press STOP C (p) to stop playback. If Disc playback is
stopped for more than five minutes, a screen saver will
appear. Details are on page 75.
1
2
6
Insert a Disc. 4
Remember, this DVD/VCR
will play only certain Discs.
See page six for details.
5
Press OPEN/CLOSE on
the DVD/VCR. 3
DVD AUDIO CD
H9231CD(EN).QX3 02.9.5 7:13 PM Page 17