General features – PhatNoise XXV-01D User Manual
Page 16
16
|
English
General features
Bypass Control
Temorarily bypassing DSP (Digital Signal
Processor) System.
1
Select the source to adjust
Press the [SRC] button.
2
Show the Multi-function display
Press the [NEXT] button repeatedly until
"DSP" appears.
Refer to
9).
3
Enter Bypass Control mode
Turn the [VOL] knob to select "DSP".
Press the [VOL] knob.
• When "2ZONE" of
cannot select "DSP".
4
Set up Bypass
Press the [VOL] knob.
"Bypass": There is no effect by DSP.
"Through": There is an effect by DSP.
• When the mode is set to "Bypass", DSP System cannot
be adjusted.
• When the mode is set to "Bypass", ODD D/A System is
not effective.
Memory mode
Storing the values of Sound Control in memory.
1
Setup Sound Control
Refer to the following operations to setup the
Sound Control.
-
2
Select the Preset Memory item
Turn the [VOL] knob to select "Preset".
Press the [VOL] knob.
3
Enter Memory mode
Turn the [VOL] knob to select "Memory".
Press the [VOL] knob.
4
Put in the memory
Turn the [VOL] knob to select "Memory1" or
"Memory2".
Press the [VOL] knob for at least 2 seconds.
The "MEMORY" display blinks 1 time.
5
Exit Memory mode
Turn the [VOL] knob to select "Return".
Press the [VOL] knob.
• "Memory1": When you press the Reset, all the
sources will be the setting value which is
registered.
• The following items cannot be registered.
Rear Volume, Balance, Fader, Position Setting, System
Q Setting
Memory Recall mode
Recall the value in the memory by the memory
mode.
1
Select the source to adjust
Press the [SRC] button.
2
Show the Multi-function display
Press the [NEXT] button repeatedly until
"S.F.C" appears.
Refer to
9).
3
Select the key function which contains the
item you wish to recall
Turn the [VOL] knob to select "S.F.C"/ "S.M.S"/
"EQ".
Press the [VOL] knob.
4
Select the Preset Memory item
Turn the [VOL] knob to select "Preset".
Press the [VOL] knob.
5
Enter recall mode
Turn the [VOL] knob to select "Recall".
Press the [VOL] knob.
6
Select the recall item
Turn the [VOL] knob to select "Recall1" or
"Recall2".
Press the [VOL] knob for at least 2 seconds.
The "RECALL" display blinks 1 time.