Pioneer DVD-V5000 - Manual (Page 61)

61
10 Barcode Stack / Command Stack
Merge Groups
1 Use the / (cursor up/down) buttons
to select the next available step.
The group divider is here.
Group001
Group002
001 02:000150-002050
002 06:22-23 * * *
003
004
005
006
007
008
Command Stack
Group(1-002) Command(1-002)
Move Select ENTER CLEAR Delete Exit HOME MENU
2 Press ENTER.
3 Use the
/ (cursor up/down) buttons
to select “COMMAND” then press ENTER.
Group001
Group002
001 02:000150-002050
002 06:22-23 * * *
003
004
005
006
007
008
Command Stack
Group(1-002) Command(1-002)
Move Select ENTER Exit HOME MENU RETURN Return
SEGMENT PLAY
CHAPTER PLAY
COMMAND
4 Use the
/ (cursor up/down) buttons
to select “MERGE GROUP.”
Group001
Group002
001 02:000150-002050
002 06:22-23 * * *
003
004
005
006
007
008
Command Stack
Group(1-002) Command(1-002)
Move Select ENTER Exit HOME MENU RETURN Return
PLAY PAUSE
STEP REV
WAIT
REPEAT GROUP
GO TO GROUP
DIVIDE GROUP
MERGE GROUP
STOP
STEP FWD
000 sec.
000
5 Press ENTER.
Group001 001 02:000150-002050
002 06:22-23 * * *
003 PLAY
004 03:123000-129000
005 05:03-07 03 2 1
006
007
008
Command Stack
Group(1-001) Command(1-005)
Move Select ENTER Exit HOME MENU RETURN Return
• The group divider is erased and the previous
group is merged with the following group.
• The group number is adjusted for each
subsequent group.
6 Save the change.
Merges are only saved when “ OK” is
highlighted and ENTER is pressed.
If “ CANCEL” is highlighted when the ENTER
is pressed, all merges are reversed.
If the power is interrupted while saving a
barcode stack/command stack during video
playback and the disc is still spinning, the
settings are not recorded.
When disconnecting the power cord, always
turn off the main power switch first (the
power indicator is not lit) or use the remote
control to set the unit to Standby mode (the
power indicator changes to orange).