Polaroid MGX-0560 - Manual (Page 22)

21
Installing the system in your car
Use the windshield mount bracket to mount the GPS in your car.
1. Loosen the nuts on the bracket hinges.
2. Slide the mounting cradle onto the bracket’s rotating head until it’s
locked into place.
3. Clean the bracket’s suction cup using the enclosed alcohol prep pad
or a cotton ball moistened with isopropyl (rubbing) alcohol. A dirty
suction cup won’t stick to any surface.
4. To mount the bracket to your windshield or side window, flip the
suction cup lever up, press and hold the suction cup against the
window, then press the suction cup lever all the way down.
5. To mount the bracket on your dashboard, peel the sticker backing
off the dashboard mount disk, then press the disk onto your
dashboard. Flip the bracket’s suction cup lever up, press and hold
the suction cup against the dashboard disc, then press the suction
cup lever all the way down.
6. Remove the battery from the GPS (if attached), then clip the GPS
into the cradle.
• Caution: Do not mount the GPS unit on your windshield in any way that
it obstructs your view of the road or interferes with your driving.
• California Drivers: California Vehicle Code Section 26708(a) provides
that drivers in California should not use suction mounts on their
windshield or side or rear windows. Polaroid recommends using the
dash mount with included adhesive disk.