Panasonic ER327 - Manual (Page 8)

Selecting the thickness of the finish
Move the trimmer down-
wards in the direction of
the arrows when cutting
around the ears.
*Cutting areas with excessive hair.
Having secured the hair clipper attachment
Make sure the switch is facing upwards and cut by
moving the trimmer downwards.
Overall hair cutting Cutting
procedure
approx. 7mm (1/4")
(Finishing thickness of
approximately 7mm)
Short finish Long finish
approx. 9mm (3/8")
Finish adjustment switch
Scalp Scalp
9mm
(3/8") 7mm
(1/4")
13
(Approx. 1/4") (Approx. 3/8")
(Finishing thickness of
approximately 9mm)
Guard
* Do not use the trimmer for the areas listed below.
The guard section of the hair clipper attachment will prevent the
blade from cutting an excessive amount of hair.
Apply the comb directly
to the scalp and move it
slowly.
90º
90º
Scalp
Do not move the trimmer
against the direction in
which the hair lays. On short hair and hair
with a tendency to stand
up, such as cropped
hair (tufting hair).
On scarce or thin areas.
On the crown.
14
Scalp