Pioneer PDP-435HDG - Manual (Page 44)

08 Basic Adjustment Settings
44
En
Power Management (PC mode only)
The system will be automatically placed into the
standby mode when no signal is received from the
personal computer.
1 Press HOME MENU.
2 Press / to select “Power Control”, and then
press ENTER.
3 Press / to select “Power Management”, and
then press ENTER.
4 Press / to select “Mode1”or”Mode2”, and then
press ENTER.
Power Management
Off
Mode1
Mode2
Item Description
Off No power management
(factory default)
Mode1 • Places the system into the standby mode
when no signal is received from the
personal computer for eight minutes.
• Even when you start using the computer
and a signal is received again, the system
stays off.
• The system is switched on again by
pressing STANDBY/ON on the Plasma
Display or a on the remote control unit.
(See page 23.)
Mode2 • Places the system into the standby mode
when no signal is received from the
personal computer for eight seconds.
• When you start using the computer and
a signal is input again, the system is
switched on.
• The system is switched on again by
pressing STANDBY/ON on the Plasma
Display or a on the remote control unit.
(See page 23.)
5 Press HOME MENU to exit the menu.
• The system is also switched on again by pressing
0 – 9 on the remote control unit; however, the system
exits the PC mode. (See page 23.)