Panasonic DMR-E80H - Manual (Page 57)

57
RQT6984
Re
fe
re
nc
e
Sound Page
Play
Displays
Remote control
No sound.
Low volume.
Distorted sound. ≥ Check the connections. Check the input mode on the amplifier if you have connected one.
≥ Turn V.S.S. off if it causes distortion.
5,
50–52
41
Cannot hear the desired
audio type. ≥ Press [AUDIO] to select the desired audio type.
≥ If “D.MIX” does not appear in the display when playing multi-channel DVD-Audio, audio output
will be the front two speakers only.
≥ You cannot change the DVD-Audio audio type if the software producer has restricted play in
stereo.
39
13
—
Cannot switch audio during
stereo or SAP broadcasts. ≥ You have used digital connection. Set “Dolby Digital” to “PCM” or connect to other equipment
using audio cables (analog connection).
≥ You cannot change the audio type when a DVD-R is in the disc tray.
≥ It is not possible to switch the audio when the recording mode is XP and “LPCM” has been
selected in the SETUP menu, “Audio Mode for XP Recording”.
‹ Select “Main” or “SAP” from “Select MTS” in the Audio menu before recording.
45, 51
—
45
Play fails to start even when
[
1 ] (PLAY) is pressed.
Play starts but then stops
immediately.
≥ Insert the disc correctly with the label facing up.
≥ This unit cannot play discs other than DVD-RAM, DVD-R, DVD-Audio, DVD-Video, Video CD,
CD and MP3 discs.
≥ The disc is dirty. Clean it.
≥ The disc may be badly scratched.
≥ You inserted a blank DVD-RAM or DVD-R.
14
10
54
—
—
A title or chapter doesn’t play
when it is selected. ≥ Some titles and chapters on DVD-Video are not played when you have changed the ratings
level. 44
Picture distorted during
search. ≥ Some distortion is normal. —
Alternative soundtrack and
subtitles cannot be selected. ≥ The languages are not recorded on the disc.
≥ You may have to use the disc’s menus to select languages.
—
19
No subtitles. ≥ Subtitles are not recorded on the disc.
≥ Turn the subtitles on.
—
40
Angle cannot be changed. ≥ This function depends on software availability. Angles can only be changed during scenes
where different angles are recorded. —
You have forgotten your rat-
ings password. ≥ Return the ratings setting to “8”.
While the disc tray is open, press and hold [
: / 6 ] and [ 5 / 9 ] on the main unit at the
same time for 5 or more seconds.
—
The display is dim. ≥ Go to the Display menu and change the display’s brightness with “FL Display”. 45
“12:00” is flashing on the
unit’s display. ≥ The clock is not set. 47
The displayed recording time
and actual recording time dif-
fer. ≥ Displayed recording time is based on the number of frames per second. This number is sub-
ject to minute variations. When recording over long periods, these variations may result in the
difference between displayed recording time and actual recording time. This is normal. —
The display doesn’t show the
correct time.
[MP3]
≥ Times may not appear correctly when searching through tracks recorded with a variable bit
rate. —
The remote control doesn’t
work. ≥ [DVD, TV] is not switched to “DVD”. Switch to “DVD” when operating this unit.
≥ The remote control and main unit are using different codes. Change the code on the remote
control or main unit.
≥ The batteries are depleted. Replace them with new ones.
≥ Point the remote control at the remote control sensor on the main unit.
≥ Remove obstacles from between the remote control and main unit.
12
46
6
6
—
Cannot operate the televi-
sion. ≥ Change manufacturer code. Some televisions cannot be operated even if you change the
code.
≥ [DVD, TV] is not switched to “TV”. Switch to “TV” when selecting the receiving channel for the
television.
9
12