Pioneer BONUS VIEW BDP-51FD User Manual

Page 52

Picture is disturbed during
playback.

Picture is dark.

• This player supports Macrovision analog copy protection
technology. With some TVs (such as with built-in video deck),
the picture will not be displayed properly when the copy
protected DVD title is played. This is not a malfunction.

• If the player and TV are connected via a DVD recorder/video
deck, etc., the picture will not be displayed properly due to
analog copy protection. Connect the player and TV directly.

No picture is displayed or
picture is not output in high
definition when playing BDs.

With some content protected discs, it may not be possible to
output the video signals from the

VIDEO output terminals, the

S-VIDEO output terminal or the COMPONENT VIDEO output
terminals. In this case, connect using an HDMI cable
(page 14).

No sound is output.

Sound is disturbed.

Is the disc played back in slow motion?

Is the disc played back in fast forward or fast reverse?

No sound is output during slow motion play and forward and
reverse scanning.

Is the disc scratched?

The sound may not be output if the disc is scratched.

Is the disc dirty?

Clean the disc (page 59).

Is the player properly connected to the other components (AV
receiver or amplifier, etc.)?

• Check that you connect the player to the audio output
terminals of a different component, etc.

• Check that you connect the player to the PHONO input
terminals of the AV receiver or amplifier, etc.

Are the connected components (AV receiver or amplifier, etc.)
properly set?

Read the operating instructions of the connected components
and check the volume, input, speaker settings, etc.

Are the audio cables properly connected?

Insert the cables firmly and all the way in.

Is the audio cable damaged?

If the cable is damaged, replace it with a new one.

Is the player connected to the TV using an HDMI cable to watch
the picture?

When connecting using component video cables, an S-Video
cable or a video cable to watch the picture, it is not possible to
listen to the sound of devices connected with HDMI cables.
Take one of the measures below (pages 14 and 17).

– To watch the picture on a device that is not HDMI

compatible, connect using either an optical digital audio
cable, coaxial digital audio cable or analog audio cables
(7.1 or 2 channels) to listen to the sound.

– To listen to the sound on an HDMI-compatible device,

connect to the TV using an HDMI cable to watch the
picture.

After one of the above measures, use Setup Navigator to reset
the player (page 20).

Audio Output Mode properly set?

Audio Output Mode is set to Multi-channel, the audio

signals may not be output properly from the

AUDIO OUT (2

ch) terminals (page 40). Set Audio Output Mode to 2
Channel.

Are the speakers properly set?

Set

Speaker Setup properly (page 40).

For some BDs, audio signals are only output from the optical
digital audio output terminal, the coaxial digital audio output
terminal or the HDMI output terminal.

Multi-channel sound is not
output.

Is the AV receiver or amplifier, etc. connected to the

HDMI

OUT terminal, the AUDIO OUT (7.1 ch) terminals or DIGITAL
OUT (COAXIAL/OPTICAL) terminal?

Read the operating instructions of the connected AV receiver
or amplifier and check the audio output settings of AV receiver
or amplifier.

Output Terminal Priority properly set?

Linear PCM (2-channel) audio signals are output from output
terminals other than the one set at

Audio under Output

Terminal Priority. Set Output Terminal Priority properly
(page 48).

Is the audio output of the connected AV receiver or amplifier,
etc., properly set?

Read the operating instructions of the connected AV receiver
or amplifier and check the audio output settings of AV receiver
or amplifier.

Problem

Check

Remedy