Philips DAB FM radio AE5900 - Manual (Page 13)

Problem
– Possible cause
• Remedy
The radio has no power.
– Power cord not securely connected.
• Connect the power cord properly.
No sound is heard.
– Volume not adjusted.
• Adjust the VOLUME.
– Headphones connected to the set.
• Disconnect headphones.
– The station is currently out of service.
• Wait until the service resumes, or tune to a new
station.
The indication “No stations available” is
displayed.
– DAB coverage is currently not available in your area.
• Wait until the coverage resumes.
– DAB signal is weak.
• Re-locate the radio, or adjust the position of
the telescopic antenna.
The indication “Station off air” is dis-
played.
– The station is currently out of service.
• Wait until the service resumes. Or, perform a scan
by pressing SCAN in DAB mode.
Poor reception
– Signal strength is weak.
• Re-locate the radio, or adjust the position of
the telescopic antenna. For DAB, you may also
perform manual tuning. See Manual tune.
I cannot hear the DAB station I have
selected.
– SELECT button was not pressed after changing a
station by pressing 1 / 2 .
• Press SELECT button to tune to the selected
station.
Note:
In case of malfunciton due to electrostatic discharge,
just reset the product (Reconnect of power source
may be required.) to resume normal operation.
Troubleshooting
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or serv-
ice centre.
WARNING :
Do not open the set as there is a risk of electric shock. Under no
circumstances should you try to repair the set yourself, as this will invali-
date the guarantee.
AE5900_05_CCR 2007.8.31 14:44 Page 13