Philips 6400 - Manual (Page 43)

iPronto User Guide
40
The Remote Control
5 Tap the Learn tool.
The label Learn appears on the iPronto icon. The Device and Page tabs are disabled. A message appears.
6 Tap the Go button in the message.
7 For learning a soft button, select the soft button you want to learn.
The button is highlighted.
-or-
For learning a hard button, press the hard button you want to learn on the iPronto.
A message appears.
8 Press and hold the button on the existing remote control.
The existing remote control sends out an IR code.
If learning succeeds, the iPronto RC beeps and OK appears on the screen.
If learning does not succeed, the iPronto beeps and Button Learn Failed appears on the screen.
Note When learning fails, keep the following guidelines in mind:
■ Make sure you aim the IR sender of the existing remote control to the iPronto’s learning eye;
■ Try increasing or decreasing the distance between the iPronto and the existing remote control;
■ Try learning in a different angle;
■ Make sure the batteries of the iPronto or of the existing RC are not low;
■ Avoid learning under bright fluorescent light or direct sunlight: it might affect the IR signals.
When learning still fails, check out the Frequently Asked Questions section on http://www.pronto.philips.com for more
information.
iPronto 1.6 IFU En .qxd 22-04-2004 17:23 Pagina 40