PYLE Audio PICDLD82I User Manual

Page 5

E-10

MUSIC EQUALIZER

- AT ANY TIME DURING PLAYBACK, PRESS

KEY REPEATEDLY TO

CHOOSE THE DESIRED SOUND EFFECT ACCORDING TO THE MUSIC YOU ARE
LISTENING TO :

EQ/ SLEEP

E-0 = EQ OFF

E1 = ROCK

E3 = POP

E4 = JAZZ

E2 = CLASSIC

ELECTRONIC VOLUME CONTROL

- THIS UNIT USES AN ELECTRONIC VOLUME CONTROL

- TO INCREASE OR DECREASE THE LOUDNESS OF UNIT, PRESS

THE VOLUME UP (+) OR VOLUME DOWN (-) KEYS RESPECTIVELY.

- RELEASE THE KEY WHEN VOLUME LEVEL IS AT THE DESIRED LOUDNESS.
- SOMETIMES, ESPECIALLY DURING LISTENING TO THE RADIO, YOU MAY NOTICE

A "CLICK-CLICK-CLICK" (REPEATING) SOUND WHEN YOU ARE INCREASING OR
DECREASING THE VOLUME. THIS IS A NORMAL CONDITION & THE SOUND WILL
DISAPPEAR WHEN YOU RELEASE THE VOLUME KEY (WHEN YOU REACH THE
DESIRED VOLUME LEVEL).

(PUSH BUTTON TYPE)

SNOOZE FUNCTION

- WHENEVER THE ALARM COMES ON, IT CAN BE TEMPORARILY SUSPENDED

FOR A SHORT PERIOD OF

9MINUTES, BY TOUCHING

THE “SNOOZE” PLATE ONCE.

- THE ALARM WILL THEN AUTOMATICALLY COME ON AGAIN AFTER

9 MINUTES “SNOOZE” PERIOD HAS ENDED.

- THE PROCEDURE CAN BE REPEATED FOR APPROXIMATELY AN HOUR.

APPROXIMATELY

E-9

OPERATION OF RADIO

- PRESS THE ON/STANDBY KEY ONCE TO SWITCH ON THE UNIT.
- PRESS THE

KEY REPEATEDLY UNTIL THE DISPLAY SHOWS "FM" SYMBOL.

- TO IMPROVE FM-RADIO RECEPTION, FULLY EXTEND THE FM-ANTENNA WIRE AND

ADJUST IT'S POSITION.

- ANYTIME IN FM STATIONS, USE THE FM MODE KEY TO SELECT

THE DESIRED MODE (

. IN SOME CASES, WHERE RECEPTION

IS POOR, IT MAY BE ADVISABLE TO SELECT “MONO” MODE, TO IMPROVE CLARITY
OF THE RADIO SIGNAL.

FM MONO/STEREO)

FUNCTION

MANUAL FREQUENCY ADJUSTMENT (SCAN MODE)

AUTOMATIC POWER OFF SLEEP FUNCTION

- THIS SET HAS A SPECIAL SLEEP TIMER FUNCTION WHICH CAN AUTOMATICALLY

SWITCH OFF THE UNIT. THIS IS USEFUL FOR SLEEPING TO MUSIC AT NIGHT.

- AT ANY TIME WHILE THE UNIT IS OPERATING, PRESS AND HOLD THE

KEY

TO ACCESS THE "SLEEP TIME". THEN PRESS THE

KEY REPEATEDLY

TO CHOOSE THE AUTOMATIC OFF TIME. THE

SYMBOL WILL BE SHOW ON

THE DISPLAY.

SLEEP

MINS

(*00 MEANS SLEEP TIMER IS DEACTIVATED)

00*

MINS

SLEEP

DIMMER FUNCTION

THIS SET HAS A DIMMER FUNCTION TO ADJUST THE BRIGHTNESS LEVEL
OF THE DISPLAY. SIMPLY ADJUST IT AS DESIRED BY PRESSING
THE DIMMER KEY REPEATEDLY (HIGH/ NORMAL/ OFF = BRIGHTNESS 100/ 50/ 0
TO REDUCE EYE STRAIN, AND TO

)

SAVE ENERGY.

THE DISPLAY WILL ALWAYS RETURN IN NORMAL-DIMMER AFTER RESET THE UNIT.

- PRESS (AND IMMEDIATELY RELEASE) THE

KEY TO “SCAN” (MANUALLY ADJUST) THE RADIO FREQUENCY “UP” OR “DOWN”
BY 1-STEP AT A TIME.

- THE RADIO DIGITAL DISPLAY WILL INDICATE THE EXACT FREQUENCY AT EACH

STEP’S POSITION.

- WHEN A DESIRED FREQUENCY OR STATION IS REACHED. IT CAN BE SAVED

INTO ONE OF THE “MEMORY” POSITIONS. (SEE “RADIO MEMORY” SECTION).

BACK/ TUNE -

NEXT/ TUNE +

RADIO MEMORY (STATION PRESET MEMORY STORAGE)

- AT ANY TIME, THE CURRENTLY DISPLAYED STATION OR FREQUENCY CAN BE

STORED INTO ONE OF THE MEMORY POSITION.

- PRESS AND HOLD

KEY

- PRESS

KEY TO SELECT DESIRED

MEMORY POSITION. (THERE ARE 30 MEMORY POSITIONS).

- PRESS

KEY ONCE TO SAVE THE SELECTED STATION INTO THE

SELECTED MEMORY POSITION.

MEMORY/ RECALL

AUTOMATIC FREQUENCY ADJUSTMENT (SEEK MODE)

- PRESS AND HOLD (FOR 2 SECONDS) THE

KEYS TO “SEEK” (AUTOMATICALLY ADJUST) THE RADIO FREQUENCY “UP” OR
“DOWN”TO THE NEXT AVAILABLE RADIO STATION.

- THE RADIO DIGITAL DISPLAY WILL INDICATE THE EXACT FREQUENCY OF THE

NEXT STATION THAT IS FOUND.

- WHEN A DESIRED STATION IS REACHED. IT CAN BE SAVED INTO ONE OF THE

“MEMORY” POSITIONS. (SEE “RADIO MEMORY” SECTION).

BACK/ TUNE -

NEXT/ TUNE +

E5 = BASS

BACK/ TUNE -

NEXT/ TUNE +

MEMORY/ RECALL

RADIO MEMORY (RECALL PRESET MEMORY STATION)

- RECALL ANY SAVED MEMORY, SIMPLY SHORT PRESS

KEY.

- PRESS

TO SELECT DESIRED MEMORY

POSITION.

- TO CLEAR THE MEMORY OF ANY POSITION, SIMPLY SAVE A NEW STATION TO

THE SAME MEMORY POSITIONS.

MEMORY/ RECALL

BACK/ TUNE -

NEXT/ TUNE +