Philips BDP5010 - Manual (Page 11)

11 EN
EN
FUNCTIONAL OVERVIEW
1.
Q (standby/on) button
• Press to turn on the unit, or to turn the unit into the
standby mode. (To completely turn off the unit, you
must unplug the AC power cord.)
• Press and hold for 10 seconds to shut down the unit.
• This button lights up in red when the unit is in
standby mode and turns off when the power is on.
2. C (stop) button
• Touch to stop playback.
3. F (pause) button
• Touch to pause playback.
4. B (play) button
• Touch to start or resume playback.
5. A (open/close) button
• Touch to open or close the disc tray.
6. Disc tray
• Place a disc after opening the disc tray.
7. LED light
• Lights up in blue when the power is on and “Ambient
Light Control” is set to “On”. (Refer to page 50.)
8. Display
• Refer to “Front Panel Display” on page 14.
9. Infrared sensor window
• Receive signals from your remote control so that you
can control the unit from a distance.
10.SD card slot
• Insert an SD Memory Card and play back the
contents in it.
1. LAN terminal
• Use to connect a modem with LAN cable.
2. HDMI OUT jack
• Use to connect to a display with an HDMI compatible
port with an HDMI cable.
3. AUDIO OUT jacks
• Use to connect a TV monitor, an AV receiver /
amplifier or other device with an RCA audio cable.
4. COMPONENT VIDEO OUT jacks
• Use to connect a TV monitor with component video
inputs with an RCA component video cable.
5. AC power cord
• Connect to a standard AC outlet to supply power to
this unit.
• Unplug this cord from the AC outlet to completely
turn off the unit.
6. Wireless LAN terminal
• Use to connect the supplied USB wireless LAN
adapter.
7. DIGITAL OUT (COAXIAL) jack
• Use to connect an AV receiver / amplifier, Dolby
Digital / DTS decoder or other device with a digital
audio coaxial input jack with a digital audio coaxial
cable.
8. VIDEO OUT jack
• Use to connect a TV monitor, an AV receiver /
amplifier or other device with an RCA video cable.
9. 7.1ch AUDIO OUT jacks
• Use to connect to an AV receiver / amplifier with
7.1ch audio cable.
Front Panel
2 1 4 5 7 6 8 9 3 10
Rear Panel
SBL
SBR
SL C FL
FR SW SR
7.1 ch AUDIO OUT DIGITAL OUT PCM/BITSTREAM
P R / C R
P B / C B
Y L
R
COMPONENT
VIDEO OUT
AUDIO
OUT
VIDEO
OUT
LAN
Wireless LAN
HDMI OUT
COAXIAL
1
7 6
3
8
4 2
9
5
Note
• Do not touch the inner pins of the jacks on the rear
panel. Electrostatic discharge may cause permanent
damage to the unit.
• This unit does not have the RF modulator.
• Do not insert a USB flash memory to the Wireless LAN
terminal. This unit is not designed to play back data
in USB flash memory.
In
tr
od
uct
ion
Con
n
ec
ti
o
n
s
B
as
ic Setup
P
layb
ack
Others
Fu
nc
ti
on
Set
u
p