Declaration of conformity, Use gap standard compliance, Compliance with emf – Philips AQ95-56F-1224KR User Manual
Page 5: Disposal of your old product and batteries, 1 important safety instructions
5
This equipment is not designed to make
•
emergency calls when the power fails. An
alternative has to be made available to allow
emergency calls.
Do not expose the phone to excessive heat
•
caused by heating equipment or direct sunlight.
Do not drop your phone or allow objects to
•
fall on your phone.
Do not use any cleaning agents containing
•
alcohol, ammonia, benzene, or abrasives as
these may harm the set.
Do not use the product in places where there
•
are explosive hazards.
Do not let small metal objects come into
•
contact with the product. This can deteriorate
audio quality and damage the product.
Active mobile phones in the vicinity may cause
•
interference.
Metallic objects may be retained if placed near
•
or on the handset receiver.
About operating and storage temperatures
Operate in a place where temperature is
•
always between 0°C to +35°C (32°F to
95°F).
Store in a place where temperature is
•
always between -20°C and +45°C (-4° F
to 113° F).
Battery life may be shortened in low
•
temperature conditions.
Declaration of conformity
Hereby Philips Consumer Lifestyle, P&A,
declares that the CD270/CD275 is in
compliance with the essential requirements and
other relevant provisions of Directive 1999/5/
EC. You can find the Declaration of Conformity
on www.p4c.philips.com.
This product has been designed, tested and
manufactured according the European R&TTE
directive 1999/5/EC. Following this directive,
this product can be brought into service in the
following countries:
1 Important safety
instructions
Power requirements
This product requires an electrical supply
•
of 100-240 volts AC. In case of power
failure, the communication can be lost.
The voltage on the network is classified
•
as TNV-3 (Telecommunication Network
Voltages), as defined in the standard EN
60950.
Warning
The Electrical network is classified as
•
hazardous. The only way to power down the
charger is to unplug the power supply from
the electrical outlet. Ensure that the electrical
outlet is always easily accessible.
To avoid damage or malfunction
Caution
Use only the power supply listed in the user
•
instructions.
Use only the batteries listed in the user
•
instructions.
Do not allow the charging contacts or the
•
battery to come into contact with metal
objects.
Do not open the handset, base station or
•
charger as you could be exposed to high
voltages.
Do not allow the charger to come into contact
•
with liquids.
Risk of explosion if battery is replaced by an
•
incorrect type.
Dispose of used batteries according to the
•
instructions.
Always use the cables provided with the
•
product.
For pluggable equipment, the socket-outlet
•
shall be installed near the equipment and shall
be easily accessible.
Handsfree activation could suddenly increase
•
the volume in the earpiece to a very high level:
make sure the handset is not too close to your
ear.
English
EN
IFU_CD270-275_05_EN.indd 5
1/5/2010 5:32:48 PM