Panasonic BT-LT900A - Manual (Page 9)

18
MAIN MENU
The underlined setting indicates the factory setting mode.
Item Setting Description Item Setting Description
GAMMA SELECT GPI
NORMAL
FILM For setting the gamma mode.
GPI:
This is the GPI setting. For
details, refer to “REMOTE
specifications” (page 22).
NORMAL: The normal gamma mode is
established.
FILM: The film mode that supports the
Varicam digital cine camera is
established. The actual film mode
setting can be changed using the
FILM GAMMA item listed next.
COLOR TEMP. USER
D93
D65
D56 For setting the color temperature.
USER: Any setting from 0 to 63 (equivalent
to a color temperature range from
3000 K to 9300 K) can be
established.
D93: This is equivalent to a color
temperature of 9300 K.
D65: This is equivalent to a color
temperature of 6500 K.
D56: This is equivalent to a color
temperature of 5600 K.
The color temperature can be set for each
gamma mode (NORMAL, FILM).
SD ASPECT GPI
16:9
4:3 For setting the aspect ratio of the SD
signals.
GPI : This is the GPI setting. For details,
refer to “REMOTE specifications”
(page 22).
16:9 : The images are displayed with a
16:9 aspect ratio.
4:3 : The images are displayed with a 4:3
aspect ratio.
SHARPNESS
MODE HIGH
LOW For setting the image sharpness.
HIGH: The images are accentuated with
fine edges.
LOW: The images are accentuated with
thick edges.
The sharpness can be set for VIDEO and
all other input channels.
SHARPNESS H 0
:
2
:
30
For setting the image sharpness in the
horizontal direction.
This item enables two settings, one for the
VIDEO input signals and one for other
signals, to be stored in the memory.
≥ While this item’s setting is selected, the
only information displayed on the screen
is this item which appears at the bottom
left regardless of the MENU POSI setting
selected on the OSD screen.
≥ The sharpness can be set for VIDEO and
all other input channels.
MONO GPI
OFF
ON For selecting monochrome images.
GPI:
This is the GPI setting. For details,
refer to “Concerning the REMOTE
specifications” (page 22).
OFF: Normal images
ON:
Monochrome images
≥ No adjustments are possible when RGB
signals are input.
≥ When ON has been selected as this
item’s setting, the setting for the
CHROMA image control is fixed at 0.
When the setting is returned to OFF, the
CHROMA setting prior to the change is
restored.
SHARPNESS V 0
:
2
:
30
For setting the image sharpness in the
vertical direction.
This item enables two settings, one for the
VIDEO input signals and one for other
signals, to be stored in the memory.
≥ While this item’s setting is selected, the
only information displayed on the screen
is this item which appears at the bottom
left regardless of the MENU POSI setting
selected on the OSD screen.
≥ The sharpness can be set for VIDEO and
all other input channels.
I-P MODE MODE2
MODE1 For switching the IP conversion mode.
MODE2: Movement compensation mode
MODE1: Normal mode
This setting takes effect when progressive
signals (1080/30P, 1080/25P, 1080/24P,
720/60P or 480/60P) are input.
VIDEO CONFIG
FILM GAMMA TYPE1
TYPE2 This enables TYPE1 or TYPE2 to be
selected as the FILM setting for the
GAMMA SELECT item.
For the differences between TYPE1 and
TYPE2, refer to the graph below showing
the gamma characteristics curves.
Luminance
Input level
Normal gamma characteristics
TYPE1 characteristics
TYPE2 characteristics