Planet Technology ICA-100 - Manual (Page 10)

Installation
7
Figure 2-1: Camera Stand
Hardware Install Procedure
ICA-100
1.Connect an Ethernet cable
Connect one end of an Ethernet cable to the LAN port located on the ICA-100 rear
panel and attach the other end to the network device (hub or switch).
2.Attach the external power supply
Connect the provided power adapter to the ICA-100 ’s connector labeled "5VDC" on
rare panel.
3.Check the LEDs
The PWR and ACT LEDs should be on.
ICA-100W
1.Attach Wireless Antenna (LAN+WLAN or WLAN mode)
Screw the 2 external Antenna provided into the antenna connector located on ICA-
100W
’s rear panel.
2.Connect an Ethernet cable (LAN or LAN+WLAN mode)
Connect one end of an Ethernet cable to the LAN port located on the ICA-100W ’s rear
panel and attach the other end to the network device (hub or switch).
3.Switch to appropriate network type
Select the desired Network communication type for ICA-100W from the Slide Switch.
Position the Slide Switch to the setting required.
4.Attach the external power supply
Connect the provided power adapter to the ICA-100W ’s connector labeled "5VDC" on
rare panel.
5.Check the LEDs
The PWR and ACT LEDs should be on.