Pride Mobility Jet10Ultra - Manual (Page 23)

Jet 10 Ultra/RevA/Apr04 www.pridemobility.com 23
Figure 12. Seat Mounting Holes
V I . C O M F O R T A D J U S T M E N T S
13. Reinstall the seat.
14. Reconnect the controller to the power pod.
15. Reinstall the rear shroud.
Seat Position
You can move the seat forward or rearward by changing the
extrusion mounting position.
To change the position:
1. Unplug the motor connectors, battery connector, and charger
inhibit.
2. Remove the seat from the power base.
3. Remove both extrusions from the bottom of the seat. See figure 9.
4. Reposition the extrusions on a different set of mounting holes. You
must move both extrusions the same number of holes either
forward or backward. See figure 12.
5. Fasten the extrusions back onto the bottom of the seat.
6. Reinstall the seat.
7. Reconnect the motor connector, battery connector , and charger
inhibit.
Seatback Angle Adjustment
If your power chair is equipped with an adjustable seatback,
you can adjust it to four (4) different angles: 90°, 102°, 105°, or
107°.
To adjust the seatback angle:
1. Remove the adjusting screws from each seat hinge. See figure 13.
2. Set the seatback at the desired angle.
3. Reinstall the adjusting screws to each seat hinge and tighten.
Reclining Seat
If your Jet 10 Ultra is equipped with a reclining seat, you can
adjust the seatback angle with the seatback release lever. The
lever is located on the right side of the seat base. See figure 14.
To adjust the recline angle:
1. Push down on the seatback release lever.
2. Lean forward or backward to the desired position.
3. Release the lever.
Armrest Width Adjustment
You can change each armrest’s width independently of the other.
NOTE: Changing the armrest width may
increase the overall width of your power
chair.
Figure 13. Seatback Angle Adjustment
SEAT
HINGE
SEATBACK
ANGLE
ADJUSTING
SCREW