Philips AQ6345/00 - Manual (Page 9)

9
TROUBLESHOOTING
English
PROBLEM
– POSSIBLE CAUSE
• REMEDY
No sound/ power
– Wrong battery polarity
• Insert batteries correctly
– Batteries exhausted
• Replace batteries
– PAUSE ; has been activated
• Switch PAUSE ; off
– Volume is turned down
• Turn up volume
– Headphones still connected, speaker muted
• Disconnect headphones
Hum when using mains adapter
– Adapter used is unsuitable
• Use a Philips SBC6650 or other standard regulated DC 3V
adapters
Poor sound/sound from one channel only:
– Headphones plug not fully inserted
• Insert plug fully
Poor cassette sound quality
– Tape head dirty
• Clean tape head (see MAINTENANCE)
Tape playback too slow/ fast
– TAPE SPEED on wrong setting
• Set TAPE SPEED to
0
If a fault occurs, first check the points listed below before taking the set for repair. If you are unable to remedy a problem by
following these hints, consult your dealer or service centre.
WARNING:
Under no circumstances should you try to repair the set yourself, as this will invalidate the
guarantee.
The model number is found at the back of the set and the production number in the battery compartment.
XP AQ 6345/00 02-02-2000 11:02 Pagina 9