Philips AQ6345/00 - Manual (Page 5)

POWER INDICATOR
Whether the set is operated on batteries or a mains adapter,
during playback or recording, the power indicator
lights
up.
• The power indicator goes out when the set is switched off.
• If battery power is low, the power indicator lights up only
dimly and you will need to replace batteries.
Batteries (not included)
1. Open battery door and insert two alkaline batteries, type
R6, UM3 or AA as indicated inside the compartment.
2. Remove the batteries from the set if they are exhausted or
not to be used for a long time.
• Batteries contain chemical substances, so they
should be disposed of properly.
Mains Adapter (not included)
1. The voltage of the DC 3V adapter must match with the
local voltage. The 3.5 mm adapter plug's 1.3 mm centre pin
also must be set to the minus pole -.
2. Connect the mains adapter to the set's DC 3V ->+
socket and a wall socket.
3. Always disconnect the mains adapter if you are not using it.
5
POWER SUPPLY
English
XP AQ 6345/00 02-02-2000 11:02 Pagina 5