Pioneer PDP-436FDE - Manual (Page 15)

15
En
Preparation 05
En
gl
is
h
Preparation
Installing the Plasma Display
Location
• Avoid direct sunlight. Maintain adequate ventilation.
• The length of the system cable used to connect the Plasma
Display and the Media Receiver is about 3 m.
• Because the Plasma Display is heavy, be sure to have
someone help you when moving it.
CAUTION
• If you place anything on the top of the Media Receiver, it will
not receive enough ventilation and will not operate properly.
NOTE
• Allow enough space around the upper and back parts when
installing to ensure adequate ventilation of the rear of the
unit.
Using the optional PIONEER stand
For details on installation, refer to the instruction manual
supplied with the stand.
Using the optional PIONEER speakers
For details on installation, refer to the instruction manual
supplied with the speaker.
CAUTION
Installing the Media Receiver
CAUTION
• Do not place a VCR or any other device on the top
of the Media Receiver.
• When installing, allow enough space on the sides
and above the Media Receiver.
• Do not block the side ventilation opening or the
rear exhaust opening of the Media Receiver.
CAUTION
Placing the Media Receiver alone in the vertical position can
result in product damage and malfunction.
Over 50 cm
Over
10 cm
Operating Environment
Operating environment temperature and humidity:
+0 ºC – +40 ºC; less than 85 %RH (cooling vents not blocked)
Do not install this unit in a poorly ventilated area, or in locations
exposed to high humidity or direct sunlight (or strong artificial
light)
ON STANDBY
STANDBY/ON PULL
OPEN
Plasma Display
Media Receiver
System cable
(approx. 3 m)
ON STANDBY
STANDBY/ON PULL
OPEN
Over 5 cm
Over 5 cm Over 5 cm
Over 10 cm
Exhaust
opening
Ventilation
opening
O N
ST
ANDBY
ST
ANDBY
/ON
PULL OPEN
PDP-506FDE.book Page 15 Wednesday, June 29, 2005 4:00 PM