Philips MCD139BDVD - Manual (Page 31)

English
31
Clock/Timer
Viewing clock
The clock (if it is set) will be shown in standby
mode.
To view the clock in any source mode
(DISC or TUNER for example), or Eco-
power standby mode
●
Press briefly CLOCK on the remote.
➜
The clock is displayed for a few seconds.
➜
If the clock has not been set, "--:--" is
displayed for a few seconds.
Setting clock
1
In standby or any source mode, press and hold
CLOCK on the remote.
➜ The clock digits flash on the display panel.
➜ If the clock has not been set, "--:--" flashes
2
Press ¡ / ™ on the set repeatedly to set the
hour.
3
Press а / б on the set repeatedly to set the
minute.
4
Press and hold MODE on the front panel for
more than 5 seconds to toggle between 12-hour
and 24-hour display.
5
Press CLOCK agian to store the setting.
➜ The clock starts working.
Notes:
– The clock setting will be erased when the system
is disconnected from the power supply.
– The system will exit clock setting mode if no
button is pressed within 25 seconds.
– To exit clock setting without storing, press STOP
on the system to exit.
Setting wake-up timer
The system can switch on to DISC or TUNER
mode automatically at a preset time, serving as
an alarm to wake you up.
IMPORTANT!
– Before setting the timer, ensure that
the clock is set correctly.
– To set a new timer, you need to
deactivate the previously set timer.
1
In standby mode, press and hold SLEEP/
TIMER on the remote for more than five
seconds to enter timer setting mode.
➜ The source and timer digits will be lighted on
the display panel.
➜ “ NO TIMER “ will be displayed briefly if
wake-up timer is not set.
2
Press DISC or TUNER to select the desired
source.
● Before setting timer, make sure the music source
has been prepared.
DISC – load the disc.
TUNER – tune to the desired radio station.
3
Press ¡ / ™ repeatedly to set the hour.
4
Press а / б repeatedly to set the minute.
5
Press SLEEP/TIMER to store the time.
● At the preset time, the selected source will play.
To deactivate the wake-up timer
● In standby mode, press and hold SLEEP/
TIMER until “TIMER OFF” is displayed on the
panel.
Notes:
– The system will exit timer setting mode if no
button is pressed within 25 seconds.
– Display shows
if activated, and disappears if
deactivated.
Setting sleep timer
The sleep timer enables the system to switch off
by itself after a set period of time.
1
Press SLEEP/TIMER on the remote control
repeatedly to select a preset time.
➜
The selections are as follows (time in
minutes):
15 ™ 30 ™ 45 ™ 60 ™ 90 ™120 ™ OFF
2
Press SLEEP/TIMER until you reach the
desired length of time.
To deactivate the sleep timer
●
Press SLEEP/TIMER repeatedly until " OFF" is
displayed, or press the STANDBY ON y
button.
pg001-038_MCD139B_05_Eng 2007.5.23, 16:16 31