Philips MCD139BDVD - Manual (Page 10)

10
English
●
Use the S-Video cable (not supplied) to connect
the system’s
S-VIDEO jack to the S-Video
input jack (or labeled as Y/C or S-VHS) on the
TV set.
● To listen to TV channels through this system, use
the audio cables (white/red, not supplied) to
connect
AUX IN1 (L/R) jacks to the
corresponding AUDIO OUT jacks on the TV set.
Using an accessory RF modulator
IMPORTANT!
– If your TV set only has a single
Antenna In jack (or labeled as 75 ohm or
RF In), you will need a RF modulator in
order to view the DVD playback via TV.
See your electronics retailer or contact
Philips for details on RF modulator
availability and operations.
● Use the supplied composite cable (yellow) to
connect the system’s
COMPOSITE VIDEO
jack to the video input jack on the RF modulator.
●
Use the RF coaxial cable (not supplied) to
connect the RF modulator to your TV’s RF jack.
Using Scart jack
1
Use the scart cable (not supplied) to connect
the system’s
SCART jacks to the corresponding
SCART input jacks on the TV set.
T O T V
T O T V
2
To listen to TV channels through this system, use
the scart cable (not supplied) to connect the
system’s
SCART jack to the corresponding
SCART output jack on the TV set.
TO TV
TO TV
Before starting operation, press AUX1/2/TV on
the remote control to select “TV” in order to
activate the input source. The music will be heard
through the speakers.
Using S-Video In jack
Connections
pg001-038_MCD139B_05_Eng 2007.5.23, 16:16 10