Pitco Frialator Self-Cleaning Burner System - Manual (Page 4)

L80-029 Rev 5 10/07 2
Follow this procedure for Installation of Self Cleaning
burners and SCBS arm:
a. Disconnect the control harness from the main gas
valve and tuck it out the way to avoid damaging the
harness during this procedure.
b. If your appliance has a solid-state control (or
auxiliary thermostat) behind the door, remove it at
this time. With a 5/16” nut driver remove the two
self-threading screws that mount the control to the
appliance, disconnect the control harness and tuck
it out of the way to avoid damaging the harness
during this procedure. Be sure to store the control
in a safe place to avoid accidental damage to it.
c. Using a 7/16” wrench, remove the pilot tubing from
the gas valve by turning the brass fitting counter-
clockwise. There is no need to remove the pilot
from the burner assembly.
WARNING
Ensure that the tank contents have been
drained before executing this step!
d. Using an 11/16” wrench or socket, loosen and
remove the drain valve nut and washer, and
remove the blue drain valve handle. Note: You may
want to place the nut and washer back on the valve
stem for safekeeping.