Planet Technology FT-90X FT-906A20 User Manual
Page 11
-8-
#
Note
:
Please refers to APPENDIX-A for detailed wiring information of the FT-90X.
To prevent from optic acceptor malfunction, check the both wires / transmitter before power on the
converter.
FT-905A Installation
FT-905A is with high reliability and flexibility to extend the distance up to 2Km, 20Km, or longer. It depends on the
100Base-FX SFP transceiver modules. The SFP transceivers are hot-plug e and hot-swappable. You can plug-in and out
the transceiver to/from any SFP port without having to power down the converter.
To install FT905A with 100Base-FX SFP, simply complete the following steps:
Step 1
: Precede with the steps 4 and steps 5 of session 2.2.1 Stand-alone Installation to connect the network cabling
and supply power to your converter.
Step 2
: Slot in the 100Base-FX SFP. Make sure both side of the SFP transfer are with the same media type, for example:
100Base-FX/2Kmto 100Base-FX/2Km, 100Bas-FX/20Km to 100Base-FX/20Km.
#
Note
:
It recommends using PLANET MFB-FX series 100Base-FX SFP on the converter. If you insert a
SFP transceiver that is not supported, the converter will not recognize it.
Step 3:
Connect the fiber cable. Attach the duplex LC connector on the network cable into the SFP transceiver.