Philips SCD610 - Manual (Page 20)

21
The battery light on the parent
XQLW ÁDVKHV UHG The rechargeable battery of the
parent unit is running low. Recharge the battery.
The battery of the parent unit
runs low quickly. The volume is set too high and
the unit consumes more power. Decrease the volume.
The video display is switched
on continuously and the unit
consumes more energy. Activate the automatic voice
activation mode to increase the
operating time.
Is my baby unit secure from
eavesdropping? The 2.4GHz digital technology
of this baby monitor guarantees
no eavesdropping.
I hear other sounds from my
parent unit. The baby unit is too far from the
baby Move the baby unit closer to
your baby with a minimum
distance of 1 metre/ 3.5 feet.
The voice activation sensitivity is
set too high. Decrease the voice activation
sensitivity.
The baby unit is close to other
sound source. Move the baby unit away from
the sound source.
The charging of the parent unit
takes a long time. 7KH XQLW LV XVHG IRU WKH ÀUVW WLPH
or after a long period of disuse. Allow at least 8 hours of
charging time.
The parent unit is switched on
during charging Switch off the parent unit
during charging.
The video monitor makes some a
high-pitched noise. The units may be too close to
each other. Move the parent unit at least
1.5 metres/ 5 feet away from
the baby unit.
The volume of the parent unit
may be set too high. Decrease the volume of the
parent unit.
The parent unit makes a buzzing
sound. The units are out of range. Move the units closer.
The parent unit picks up signals
from other appliances or baby
monitors. Move the parent unit away
from other 2.4GHz wireless
appliances such as telephones.
The rechargeable battery of the
parent unit may be low. Recharge the battery.
7KH YLGHR GLVSOD\ ÁLFNHUV The units are nearly out of range. Move the units closer.
The parent unit picks up signals
from other appliances or baby
monitors.
Move the parent unit away
from other 2.4GHz wireless
appliances such as telephones.
The rechargeable battery of the
parent unit may be low. Recharge the battery.
There is no image on the video
display when the power on light
is on. The parent unit may be in the
automatic voice activation mode. Press the automatic voice
activation button again to
switch on the video display.
The image on the video display
is unclear. The display brightness may be set
too low or too high. Adjust the display brightness.
EN