Philips SCD610 - Manual (Page 12)

13 EN
Tip
‡ Charging normally takes 5 hours, but it takes longer
when the parent unit is switched on during charging. To
keep the charging time as short as possible, switch off
the parent unit during charging.
‡ When the battery is fully charged, the parent unit can
be used cordlessly for approximately 7 hours if it is in
voice activation mode. If the video is on continuously,
the parent unit can be used cordlessly for approx. 5
hours.
Set up the baby unit
Caution
‡ Keep the baby unit out of the reach of the baby. Never
place the baby unit inside or mount it on the baby's
bed or playpen.
Note
‡ If you use wireless devices, microwave oven or a DECT-
system and you experience interference on either the
parent unit or baby unit, move the parent unit further
away until there is no more interference.
1
Place the baby unit at least 1 meter/3.5
feet away from your baby.
2
Place the baby unit on a stable surface.
You may also mount the baby unit on a
wall mount which is provided. For more
information, please refer to the next
section.
3
Adjust the position of the baby unit in a
way that ensures the best visibility of your
baby.
4
Insert the plug into the baby unit and put
the adapter in a wall socket.
5
Place the parent unit within the operation
range of the baby unit. Make sure it is at
least 1.5 metre/5 feet away from the baby
unit to avoid acoustic feedback.
6
For more information on the operating
range, see section "Operating range" below.
Tip
‡ Position the baby unit at a higher level to get a good
overview of the baby's bed or playpen.
Wall mount the baby unit
Caution
‡ When the baby unit is wall mounted, manage the
FRUG RI WKH EDE\ XQLW VR WKDW LW LV À[HG RQ WKH ZDOO QRW
accessible by the baby.
1
Use the paper template to mark the
positions of the three screws to wall
mount your baby unit.
2
Drill holes at the three positions.
3
Place wall plugs in the wall.