Philips SCD610 - Manual (Page 15)

16 EN
6 Menu
1
Press menu button on the parent unit.
» Menu is displayed.
2
Press +/- to move up or down the memu/
submenu, and press / to move left or
right across menu/submenu.
3
7R FRQÀUP SUHVV WKH FHQWHU NH\ RU
4
To exit, press .
Zoom & Pan
1
Press menu button.
2
Select [ZOOM & PAN] from the menu to
zoom in and out the view, and pan your
view.
Menu option Description
[ZOOM+] Zoom in the view
[PAN] Pan the view to adjust
the focus of the view
[ZOOM-] Zoom out the view
Voice activation
Voice activation
When the voice activation mode is on, the
video display only switches on when the baby
unit picks up a sound. As long as no sound is
detected, the video display is off to save power.
When you press a key or a sound is detected,
the parent unit is activated, and will be off again
after 20 seconds time-out. The timer is reset
each time when:
‡ A sound exceeds the set voice
activation sensitivity.
‡ One button on parent unit (menu, +, -,
, ) is pressed on.
Turn on voice activation
Press the button on the side of the parent
unit, and the voice activation indicator slowly
blinks.
Change voice activation sensitivity
1
Press menu button on the parent unit.
2
Select [VOICE ACTIVATION SENSITIVITY]
of the baby unit.
Menu option Description
[HIGH] High voice activation sensitivity
[MID] Medium voice activation
sensitivity
[LOW] Low voice activation sensitivity
Note
‡ When voice activation is active, the LOOP ALL CAMs
in the switch CAM dialogue is not available.
‡ When the LOOP ALL CAMs is active, the VOICE
ACTIVATION function is not available. An info screen
will be shown when you press the VOX button.
When [VOICE ACTIVATION SENSITIVITY] is
set higher,it picks up a softer sound.
Adjust brightness
1
Press menu button on the parent unit.
2
Select [ADJUST BRIGHTNESS].
3
Press +/- to adjust the brightness of the
video display.
Add/delete cameras
Add a new camera
A maximum of 4 cameras can be paired to a
parent unit. The menu has 4 positions named
CAM1 up to CAM4. Your default setting will be
at CAM1. You can select any of the positions
in the list to assign a camera. It is up to you to
decide which camera is which item in the list.