Philips 27DVCR55S - Manual (Page 33)

Rerecording (Tape Duplication) 33
• Unauthorized recording of copy-
righted television programs,
videotapes, or other materials
may infringe on the rights of
copyright owners and violate
copyright laws.
• Different brands of equipment
may operate differently.
• Make sure all connections are
secure. Otherwise, you may not
record both picture and sound.
• Programs that are copyright
protected may not record clearly.
• You cannot record a DVD onto a
videotape using this
TV/VCR/DVD.
• You can use this connection to
simply view tapes playing on a
camcorder or VCR at the
TV/VCR/DVD. Follow steps 1, 2,
and 4 for connections and AUX
setup. Then play the tape on the
camcorder, etc., as usual.
1 Make the connections shown above. Use audio
and video cables (not supplied). Connect the
source unit (VCR or Camcorder) to a power
source after connections are made.
2 The VCR or Camcorder will play your tape. Insert a
prerecorded tape in the source unit. If play
begins, press STOP on the VCR or Camcorder.
3 The TV/VCR/DVD will record your tape. Insert a
blank videotape in the cassette compartment
of the TV/VCR/DVD. Make sure the tape’s record
tab is intact and the TV/VCR/DVD power is on.
4 Point the TV/VCR/DVD remote control at the
TV/VCR/DVD. Press SELECT or CH. o/p until
AUX appears on the screen. The TV/VCR/DVD is
now in Line Input or Auxiliary mode.
5 Press SPEED until the desired tape speed (SP
or SLP) appears in the lower left corner of the
screen.
6 Press PLAY on the VCR or Camcorder and
REC(ord)/OTR on your TV/VCR/DVD at the
same time. Videotape copying will begin.
7 To stop copying, press STOP/EJECT C A on
the TV/VCR/DVD, then stop the tape on the
VCR or Camcorder.
R L AUDIO VIDEO HEADPHONE
OP/EJECT
VIDEO
OUT
L
AUDIO
OUT
R
AUDIO and VIDEO OUT Jacks on source unit
(VCR or Camcorder)
AUDIO and VIDEO In
Jacks on TV/VCR/DVD
Audio Cables from
AUDIO OUT to AUDIO In
Video Cable from
VIDEO OUT to VIDEO In
Helpful Hints