Planet Technology ADSL 2/2+ Router with USB Port ADE-3410v2 - Manual (Page 62)

62
2. Question: Why LINK/ACT LED is not lighting?
Answer:
• Check the connection between the ADSL router and your computer or Hub/Switch.
• Check your PC or Hub/Switch running status and make sure them are working
normally.
• Check your network cable for connecting the Router with other device:
For PC, you should use the crossover cable;
For Hub/Switch, you should use straight through cable.
3. Question: Why LINK LED is not lighting?
Answer:
Check the connection between the ADSL “line” port and the wall jack.
4. Question: Why cannot visit Internet with LINK LED is on?
Answer:
Make sure following information has been input correctly:
VPI/VCI
Username/Password.
5. Question: Why cannot open the Router configuring web page?
Answer:
Follow below steps to check the communication between the computer and Router:
Click start -> run (input ping demands) -> Ping 192.168.1.1 (ROUTER IP Address).
If cannot reach the router, please check following configuration:
• The type of the network cable
• The connection between the router and computer
• You computer’s TCP/IP setting
6. Question: How to load the default setting after incorrect configuration?
Answer:
Press “reset” button and holds around 10s to load the default configuration.
The router’s default IP address: 192.168.1.1/255.255.255.0,
User/password: admin/admin