Panasonic KX-TG5438 - Manual (Page 38)

Programmable Settings
38 For assistance, please call 1-800-211-PANA (7262).
Telephone settings
Dialing mode
If you cannot make calls, change this
setting depending on your telephone line
service.
“Tone” (default): For tone dial service.
“Pulse”: For rotary pulse dial service.
1
Press {MENU}.
2
Scroll to “Initial setting” by
pressing {V} or {^}, then press {
>}.
3
Scroll to “Set tel line” by pressing
{V}
or {^}, then press { >}.
4
Scroll to “Set dial mode” by pressing
{V}
or {^}, then press { >}.
5
Press {V} or {^} repeatedly to select
the desired setting.
6
Press {Save}, then press {OFF}.
Flash time
The flash time depends on your telephone
exchange or host PBX.
You can select: “90ms” (milliseconds),
“100ms”, “110ms”, “250ms”, “300ms”,
“400ms”, “600ms”, or “700ms” (default).
1
Press {MENU}.
2
Scroll to “Initial setting” by
pressing {V} or {^}, then press {
>}.
3
Scroll to “Set tel line” by pressing
{V}
or {^}, then press { >}.
4
Scroll to “Set flash time” by
pressing {V} or {^}, then press {
>}.
5
Press {V} or {^} repeatedly to select
the desired setting.
6
Press {Save}, then press {OFF}.
Note:
L The setting should stay at 700 ms unless
pressing {Flash} fails to pick up the Call
Waiting call.
L
If the unit is connected via a PBX, certain
PBX functions (call transferring, etc.)
may not work correctly. Consult your
PBX supplier for the correct setting.
Line mode
The line mode is preset to “B” and
generally should not be adjusted. If “Line
in use
” on the handset is not displayed
properly, the line mode selection is
incorrect. Set line mode to “A”.
1
Press {MENU}.
2
Scroll to “Initial setting” by
pressing {V} or {^}, then press {
>}.
3
Scroll to “Set tel line” by pressing
{V}
or {^}, then press { >}.
4
Scroll to “Set line mode” by pressing
{V}
or {^}, then press { >}.
5
Press {V} or {^} repeatedly to select
the desired setting.
6
Press {Save}, then press {OFF}.
TG5438_5439.book Page 38 Tuesday, January 11, 2005 4:46 PM